Make conclusions reached on the following network configurations. Switch#show vtp status

Switch#show vtp status

VTP Version : 2

Configuration Revision : 8

Maximum VLANs supported locally : 255

Number of existing VLANs : 11

VTP Operating Mode : Client

VTP Domain Name : cisco

VTP Pruning Mode : Disabled

VTP V2 Mode : Disabled

VTP Traps Generation : Disabled

MD5 digest : 0x6E 0xFD 0xC9 0x25 0x93 0x8C 0x7E 0x29

Configuration last modified by 0.0.0.0 at 3-1-93 00:01:46

VLAN Trunking Protocol (VTP) is a Cisco proprietary protocol that propagates the definition of Virtual Local Area Networks ( VLAN ) on the whole local area network.

The protocol version VTP.

2. Configuration revision number, this parameter is required for the following situations:When VTP server sends information about VLAN, this number is used to indicate the novelty of "freshness" base.

Mode in which the switch is running at the moment.

VTP Pruning - a technology invented to reduce the load on the main channels (trunks). The main thing is that there is no need to send the information about the switch VLAN if it has no active ports in this VLAN. Also does not send broadcast packets to the switch if it has no active ports in the VLAN the sender Broadcast.

Without VTP pruning

VTP V2 is not much different than VTP V1. The major difference is that VTP V2 introduces support for Token Ring VLANs. If you use Token Ring VLANs, you must enable VTP V2. Otherwise, there is no reason to use VTP V2. Changing the VTP version from 1 to 2 will not cause a switch to reload.

If the traps generation are enabled, the switch will notify the network management station when a new VTP message is sent.

With VTP pruning

10. Make conclusions reached on the following network configurations

VLAN Name Status Ports                                   --------------- --------- --------------------------------------1 default active Fa0/6,- 0/24

Test      active Fa0/1, Fa0/2

VLAN0010 active Fa0/4, Fa0/5

15 VLAN0015 active Fa0/3

Other ports(fa 0/6- 0/24) in Vlan default, *you can also draw hosts*

 

12  

 

13 Make

 

14 Make conclusions reached on the following network configurations

!

interface FastEthernet0/1

switchport mode access

switchport access vlan 10

!

interface FastEthernet0/2

switchport mode access

switchport access vlan 2

!

interface FastEthernet0/3

switchport mode access

switchport access vlan 2

!

interface FastEthernet0/22

switchport trunk encapsulation dot1q

switchport mode trunk

switchport trunk allowed vlan 1,2,10

!

SW2 nad narisovat!!!!

 

 

15. Make conclusions reached on the following network configurations

!

vlan 2,10,15

!

interface FastEthernet0/1

switchport mode trunk

switchport trunk allowed vlan 1,2,10,15

!

interface FastEthernet0/2

switchport mode trunk

switchport trunk allowed vlan 1,2,10

!

Configuration of Switch 3

⇐ Предыдущая1234Следующая ⇒

Поделиться: